RX2050 - N/A
a) in all operation modes
• built-in test equipment (BITE) with error indication on the transceiver display;
• operating data programming from external equipment;
• emergency erasure of operating data on fixed frequency channels including encryption unit codes and information for FH networks, including TRANSEC and COMSEC;
• switching on/off of acoustic signaling by transceiver operators;
• backlit display and keypad;
• adjustable display contrast;
• operating channel signal reception signaling by a LED on the transceiver panel;
• whisper mode with reduced audio frequency output power;
• received signal loud monitoring with volume regulation and LED monitor signaling;
• service information display – firmware;
• remote receiver control via REMOTE connector and RS232 or RS485 communication link and PRC20 protocol;
• simple control.
b) in fixed frequency operation
• up to 10 channel presents from the entire 25 MHz to 145.9875 MHz frequency range, number of preset channels is reduced when occupied by FH networks;
• simplex reception;
• 150 Hz sub-tone squelch or signal squelch (only signal in VHF II);
• reception via built-in encryption unit compatible with RF13, RF20, RF2050;
• reception of short coded messages – FLASH with opposite transceiver identification;
• keypad channel programming;
• fixed frequency channel preset scanning;
• operating frequency setting in 6.25 kHz. 8.33 kHz, 25 kHz or 1 MHz steps.
c) in FH operation
• up to 6 network presets;
• operation in 30.000 MHz to 87.975 MHz frequency range;
• secured TRANSEC operation and encrypted COMSEC operation;
• compatible with RF20, RF2050 transceivers;
• HLC, HLG and 121.500 MHz (HLA) frequency monitoring;
• optional frequency hopping operating modes – FH, DFF, FCS and MIX with quick transition to HLC, HLG or HLA reception;
• reception of alert message to all network users;
• reception of selective communication from MASTER transceiver;
• reception of short text messages (maximum 156 characters);
• INTERLEAVING switching off for close-to-the-limits communication.
| BASIC SPECIFICATION | |
|---|---|
| Operating frequency | 25 MHz to 145.9875 MHz |
| Nominal input impedance | 50 Ω |
| Frequency sub-bands | |
| HF | 25 MHz to 29.975 MHz |
| VHF I | 30 MHz to 108 MHz |
| VHF II | 117.975 to 140 MHz |
| VHF III | 140.025 to 145.9875 MHz |
| Type of received modulation | |
| HF | F3E (FM) |
| VHF I | F3E (FM) |
| VHF II | A3E (AM) |
| VHF III | F3E (FM) |
| Channel spacing | |
| HF | 25 kHz |
| VHF I | 25 kHz; 12.5 kHz; 6.25 kHz |
| VHF II | 25 kHz; 8.33 kHz |
| VHF III | 25 kHz; 12.5 kHz |
| Number of operating channels for 25 kHz channel spacing | |
| HF | 200 |
| VHF I | 3121 |
| VHF II | 882 |
| VHF III | 239 |
| Number of preset channels | up to 10 |
| Number of frequency-hopping channels | up to 6 |
| RECEIVER SPECIFICATIONS | |
| Receiver sensitivity | |
| 25 MHz to 29,975 MHz | 0.6 μV |
| 30 MHz to 90 MHz | 0.7 μV |
| 90.00625 MHz to 108 MHz | 0.5 μV |
| 117.975 MHz to 140 MHz | 0.5 μV |
| 140.025 MHz to 145.9875 MHz | 0.5 μV |
| Dynamic two-signal selectivity for adjacent channel | min. 57 dB |
| Suppression of intermediate frequencies | min. 80 dB |
| Suppression of image-channel frequencies | min. 60 dB |
| Suppression of spurious receptions at > 10 % detuning from operating frequency | min. 70 dB |
| AUDIO FREQUENCY OUTPUT SPECIFICATIONS | |
| Range of effectively transmitted frequencies | |
| narrow band audio | 300 Hz to 3000 Hz |
| wide band audio | 10 Hz to 11000 Hz |
| Audio frequency levels on AF connector | |
| narrow band audio | min. 200 mW, adjustable level up to 8 Ω |
| narrow band audio | min. 775 mV, constant level up to 600 Ω |
| wide band audio | 1000 mV, constant level up to 600 Ω |
| Acoustic pressure of the built-in speaker | min. 85 dB at maximum volume |
| Non-linear distortion factor | up to 10 % |
| POWER SUPPLY SPECIFICATIONS | |
| Nominal supply voltage | 12 V or 24 V |
| Limit supply voltage range | 10 V to 33 V |
| Maximum consumption | 0.625 A at 24 V |
| 1.25 A at 12 V | |
| Consumption during synchronization hold | up to 0.015 A from 24 V backup supply |
| SPECIAL OPERATION MODES SPECIFICATIONS | |
| Range of operating frequencies in FH modes | 30 MHz to 87.975 MHz |
| Number of monitored frequencies in FH modes | 3 (two programmable, third 121.5 MHz) |
| Frequency hopping modes | |
| FH | secure frequency hopping |
| DFF | secure digital fixed frequency |
| FCS | secure free channel search |
| MIX | mix mode FH + FCS |
| Time to initial synchronization | up to 5 s |
| Synchronization hold | 48 hours |
| Synchronization hold with disconnected power supply | 50 s |
| Minimum number of operation frequencies in FH mode | 1 |
| Hopping rate | 100 hops/s |
| MECHANICAL SPECIFICATIONS | |
| Maximum dimensions | 184 mm x 196 mm x 175 mm [w x h x d] |
| Maximum weight | up to 6.5 kg |
| Resistances | |
| Operating temperature | -40° C to +70 °C |
| Mechanical and climatic resistance | according to MIL-STD-810E |
| EMC immunity | according to MIL-STD-461E |
| Mains power immunity | according to MIL-STD-1275B |
| RX2050 operating instructions | 2310.010.81 |
|---|---|
| RF2050 short operating instructions | 2310.011.12 |
RX2050 - EPM receiver set
Set consists of RX2050 EPM receiver and accessories. RX2050 receiver is a device intended for installation in mobile devices. It...
| Type designation | Name | PN (RN) | KCM | NSN |
|---|---|---|---|---|
| RX2050 | EPM receiver set | 2310.000.83 |
Mobile set frame
The frame is designed for installation of the RF2050 mobile EPM transceiver in all wheeled and tracked vehicles. The transceiver...
RF13.3 - Handset
Handset holder
2.6 m VHF vehicle antenna
The antenna is designed for fixed installation on all types of wheeled and tracked vehicles. It has omnidirectional radiation pattern...
Vehicle antenna VHF/UHF 1.3 m
The antenna is designed for fixed installation on all types of wheeled and tracked vehicles. It has omnidirectional radiation pattern...
Vehicle antenna VHF 1.6 m
The antenna is designed for fixed installation on all types of wheeled and tracked vehicles. It has omnidirectional radiation pattern...
Vehicle antenna VHF/UHF 2.7 m
The antenna is designed for fixed installation on all types of wheeled and tracked vehicles. It has omnidirectional radiation pattern...
1.88 m VHF vehicle antenna
It is intended for fixed mounting on the metal bodywork of the vehicle. A characteristic feature of the antenna is...
Groundplane antenna
The antenna is intended for use on stationary posts. The antenna can be installed on all types of masts supplied...
Discon antenna
RF13.8 - Hang-up antenna
This antenna is used for operation of the RF13 transceiver from trenches, forests or from buildings. The antena consits of...
PD13 - Long-wire antenna
Telescopic winch driven mast 10 m
Antenna mast
It is intended for use in field conditions to install all types of GROUNDPLANE antennas supplied by DICOM. Individual sections...
PK1302 - Fill gun set
The set is used for operation data programming of the RF13 (including RF1301) and RF20 transceivers. The set consists of...
RC20 - Remote control unit set
Set consists of RC20 remote control and cable for transceiver connection. The remote control unit is intended for remote control...
RF cable
High frequency protection 1 GHz 200 V 400 W
RF headsets
The RF product line headsets are designed for RF20 and RF13 radio system transceivers.
| Type designation | Name | PN (RN) | KCM | NSN |
|---|---|---|---|---|
| Mobile set frame | 7007.100.14 | 0064570002710 | 5975160055891 | |
| RF13.3 | Handset | 2022.100.51 | 0064333000731 | 5965160034142 |
| Handset holder | 2026.700.01 | 0064662900760 | 5965160034225 | |
| Power supply cable 3 m | 1050.126.02 | 0067100055749 | 5995160055907 | |
| Grounding | 1050.993.01 | 0064681901249 | 5995160034143 | |
| 2.6 m VHF vehicle antenna | 2036.100.23, 2036.100.24 | |||
| Vehicle antenna VHF/UHF 1.3 m | 2036.100.34 | |||
| Vehicle antenna VHF 1.6 m | 2036.100.35 | |||
| Vehicle antenna VHF/UHF 2.7 m | 2036.100.36 | |||
| 1.88 m VHF vehicle antenna | 2036.100.40 | |||
| Groundplane antenna | 2036.100.38 | |||
| Discon antenna | 2036.100.18 | 0064681101609 | 5985160039132 | |
| RF13.8 | Hang-up antenna | 2036.100.11 | 0064681101065 | 5985160024749 |
| PD13 | Long-wire antenna | 2036.100.10 | 0064681101577 | 5985160038730 |
| Telescopic winch driven mast 10 m | 2036.100.20 | 0064681500217 | 5985160039124 | |
| Antenna mast | 2036.100.39 | |||
| PK1302 | Fill gun set | 2320.000.20 | 0067100047544 | 5820160049721 |
| RC20 | Remote control unit set | 2312.000.01 | ||
| Antenna cable (10 m) | 2011.904.02 | 0064301010924 | 5995160020406 | |
| Antenna cable (3 m) | 2011.904.01 | 0064301010443 | 5995160034134 | |
| RF cable | 1050.405.02 | |||
| High frequency protection 1 GHz 200 V 400 W | 5605002002 | |||
| RF headsets |
